HOW TO INSTALL
This manual explains how to install the ProTANKtion in just seven steps. For assembly you will need:
STEP 1.
Preparation
This manual explains how to install the ProTANKtion in just seven steps. For assembly you will need:
- a ratchet or an allen key with a 4mm hexagon bit.
- filter wrench.
If you have a Scania filler neck, no adapter is required and you may proceed to step 4.
STEP 2.
Mounting the adaptor
Place the adapter in the fuel tank bayonet neck and rotate it half a turn.
Fasten the adapter as tightly as possible with the filter wrench, using the 3mm gasket if necessary.
STEP 3.
Securing the adaptor
Tighten the four grub screws firmly, using a ratchet or allen key. Ensure that the grub screws are flush within the screw thread.
Two of the grub screws clamp the adapter in the filler neck and the other two block the screw-thread, which makes it impossible to unscrew the adapter.
STEP 4.
Mounting the ProTANKtion®
Place the ProTANKtion® in the adapter or in the original Scania filler neck (the screw-thread is identical in both types).
STEP 5.
Securing the ProTANKtion® 1
Firmly tighten the ProTANKtion® into the adapter using a filter wrench. Caution! When placing the ProTANKtion into the adapter, the shear bolt has to be placed on the adapter between the markers.
STEP 6.
Securing the ProTANKtion® 2
Place a plug in the filler neck. Carefully tighten the shear bolt with a ratchet or allen key. When the bolt is at the correct tension, it will break off. The plug prevents the head of the shear bolt from falling into the tank.
The stainless steel tube can now be slide partially out of the ProTANKtion®. This tube makes it possible to fill up easily.
STEP 7.
Fixing the cap
Attach the chain of the cap to the stainless steel tube.
ProTANKtion® is now completely installed and ready for use.